When does the Edit Buffer Line appear?

When does the Edit Buffer Line appear?

• A. It appears when a jobs content is displayed in Editing or Management Mode
• B. Only during startup
• C. Only after a system reboot
• D. Whenever a new job is loaded

Answer: (B)

The Edit Buffer Line is a temporary interface element that only appears during the startup sequence of the controller. At power-on or a cold start, the system goes through an initial editing state where this line is available to input or inspect the buffer before normal operation begins. Once the system finishes booting and you’re operating in regular editing or management modes, the line isn’t shown, because standard editing is handled through the usual editors and interfaces. So, you’ll only see it when the system is starting up, and a full restart would bring it back into view.

The Edit Buffer Line is a temporary interface element that only appears during the startup sequence of the controller. At power-on or a cold start, the system goes through an initial editing state where this line is available to input or inspect the buffer before normal operation begins. Once the system finishes booting and you’re operating in regular editing or management modes, the line isn’t shown, because standard editing is handled through the usual editors and interfaces. So, you’ll only see it when the system is starting up, and a full restart would bring it back into view.